Loading... Please wait...

MKVS FSR Mounts

Hover over image to zoom

  • Image 1
$9.95
SKU:
MKVSFSRM
Shipping:
Calculated at checkout

 Product Description

MKVS FSR Mounts

These bed mounts are designed for 170mm radius beds. They work well with our FSR Kit. You can also use them without FSRs; just flip the mount so the smooth side is facing the print bed.

  • Bed mounts (x3)
  • Bed clamps (x3)

Note: these brackets fit the UltiBots Mini Kossel V-Slot printer design that uses 2020 V-Slot extrusion.  If using 1515 extrusion, they will need to be adapted.

 Find Similar Products by Category

 Product Reviews

  1. Excellent, and simple installation

    Posted by R Sela on 3rd Jun 2017

    I would rate the product "perfect", but I ran into one tiny issue when installing the blocks. The raised area on the back of the block that is supposed to keep it from rotating by riding in the V-slot runs into the top of the spring-nut, and you can't tighten it so it grips the v-slot unless you remove some material. In a 'new' installation, you would use square-nuts, and there would be no problem, but in a retrofit situation, using spring nuts to avoid the need to disconnect the frame member from the corner bracket, you end up having to scrape some material off the block. Other than that, the fit of the silicone pads in the holes is perfect... just enough friction to keep them from popping out...Very well-designed.


You Recently Viewed...

 

Follow us on

Copyright 2017 UltiBots LLC. All Rights Reserved.
Sitemap |

Click the button below to add the MKVS FSR Mounts to your wish list.